現在，很多餐廳都有油煙凈化器，但是如果長時間使用油煙凈化器，時間長了，難免會出現故障，今天小編就來給大家講解一下，
濟南油煙凈化器常見的故障以及解決辦法。
At present, many restaurants have lampblack purifiers. However, if you use the lampblack purifier for a long time, it will inevitably fail. Today, I will explain the common failures and solutions of the lampblack purifier in Jinan.
一、油煙凈化器出現漏油的情況
1、 Oil leakage of oil fume purifier
1.檢查設備內集油盤是否忘了清洗造成集油過多，如果是要及時集油盤上的油。
1. Check whether the oil collecting pan in the equipment is too much due to forgotten cleaning. If so, remove the oil on the oil collecting pan in time.
2.檢查設備內部接縫是否有破損，如密封膠破損則應立即更換密封膠條。
2. Check whether the internal joints of the equipment are damaged. If the sealant is damaged, replace the sealant strip immediately.
二、設備頻繁產生較大噪音，甚出現火花。
2、 The equipment frequently produces loud noise, even sparks.
1.檢查機箱內電場處的極針有沒有偏移，如有偏差，應予以糾正，這是常見的一種油煙凈化器清洗方法，因為一些清洗人員不仔細或不規范，極針就有可能撞歪，這樣可以引起持續較大的噪音，甚產生靜電火花。
1. Check whether the pole pin at the electric field in the chassis is offset. If there is any deviation, it should be corrected. This is a common cleaning method for the oil fume purifier. Because some cleaning personnel are not careful or not standardized, the pole pin may be skewed, which can cause continuous loud noise, and even produce electrostatic sparks.
2.油煙濾清器供電電壓太高。有時電壓過高也會出現持續的響聲，此時要進行電壓調節，一般這類操作不用戶自行操作，好讓人員指導進行調節，避免電壓調節過低影響凈化效率。
2. The power supply voltage of lampblack filter is too high. Sometimes the voltage is too high and there will be a continuous noise. At this time, the voltage should be adjusted. Generally, this type of operation is not recommended for users to operate on their own, so that professionals can guide the adjustment to avoid the impact of too low voltage adjustment on purification efficiency.
3.油煙凈化器如果是剛洗完還沒干透，就放進去使用，也會有響聲，干燥后會自動恢復。
3. If the lampblack purifier has just been washed and is not completely dry, it will be put in for use. It will also make a noise and will automatically recover after drying.
4.電場中存在雜質。常常遇到客戶告訴我們，他們的設備明明被清洗干凈，為什么會有很大的噪音或產生靜電火花？在我們?nèi)藛T對油煙凈化器進行抽空檢查時，發現有一些油煙凈化器掉了一個螺釘，有的用鋼絲球去刷電場，造成鐵絲脫落，這些都是由于疏忽造成的。
4. There are impurities in the electric field. Customers often tell us why their equipment is so noisy or generates static sparks when it is cleaned? When our professional personnel vacuumed and inspected the oil fume purifiers, they found that some oil fume purifiers lost a screw, and some used steel wire balls to brush the electric field, which caused the iron wire to fall off. These were all caused by negligence.
三、觸碰油煙凈化器殼體，感受電流。
3、 Touch the oil fume purifier housing to feel the current.
1.油煙凈化器外殼未按規范接地，油煙凈化器內部有高壓電場，因此須對其進行接地，若沒有接地則有可能發生外殼帶電。
1. The enclosure of the lampblack purifier is not grounded according to the safety specifications. There is a high-voltage electric field inside the lampblack purifier, so it must be grounded. If there is no grounding, the enclosure may be electrified.
2.油煙凈化器內電線外皮由于老化或因其它原因而損壞(如鼠咬、刮擦等)而受到損壞，從而導致與外殼接觸，從而產生漏電。
2. The wire skin inside the oil fume purifier is damaged due to aging or other reasons (such as rat bite, scraping, etc.), which leads to contact with the shell, resulting in electric leakage.
The above are the common problems and solutions of the lampblack purifier. I hope they can help you solve the problems. If there is something you don't understand, welcome to our website http://www.888qp03.com Ask about it!
上一篇：通風管道的詳細特色包含幾點
下一篇：廚房排煙設備安裝的基本常識
